Your cart is empty.
Tap a colorway to add a belt.
Set it up once
Your Dartee belt arrives ready to fit any waist from 0″ to 46″. Cut it to your size, dial in the ratchet fit, snap the magnetic buckle, and add your holders, and you’re set for good. Here’s the whole thing, step by step.
0-46″
One belt, every waist
⅛″
Adjusts every 1/8 inch
1 min
To size it perfectly
∞
Lifetime warranty
Step One
Measure your waist, then trim the strap down to your size with scissors. The back of the strap has size markings to cut on, and one belt covers every waist from 0″ to 46″.
Pro tip:Cut conservatively, you can always cut it shorter, so trim a little long the first time and dial it in.
Step Two
Pull the strap through until the belt sits snug at your waist. The ratchet clicks every ⅛ inch across the full 0-46″ range, a perfect-click system that locks you in at an exact, dead-on fit.
Tip:Tailored for the tee. Forgiving after the turn.
Step Three
Drop your magnetic ball marker straight into the face of our patented magnetic buckle, it locks in flush and holds tight through your whole round. No pockets, no searching, always right where you reach for it.
Step Four
Secure the detachable tee and glove holders onto the strap wherever they feel right. Now your essentials ride on your hip, out of your pockets and off the cart.
Step Five
When you’re off the course, your belt has a home. Every Dartee ships in premium packaging built to keep it clean, protected, and looking sharp between rounds, and it makes one hell of a gift.
Just a pair of scissors to trim the strap to your size, that’s the only step that needs anything, and it takes about a minute. Everything else is hand-tight: thread, ratchet, snap.
There’s only one size to order. Every Dartee belt fits any waist from 0″ to 46″, you set the fit with the ratchet and trim the leather once to lock it in. No half-sizes, no guessing.
You don't have to measure, there are size markings on the back of the strap to cut on. Set your fit first, and if you're worried, cut a size bigger than your waist, you can always trim more later. Slide the buckle off, cut on your mark, and slide it back on.
Reach out to us. If we have a replacement in the warehouse, we will exchange it. We believe in taking care of people who take a shot.
To fasten the buckle to the belt, slide the strap into the buckle. On the back of the buckle, firmly press down on the locking lever to secure the buckle to the strap.
Once the buckle is attached, slide the opposite end of the strap into the front of the buckle. The magnetic ratchet mechanism will automatically engage, allowing you to tighten the belt to your perfect fit.
⚠️ Please note: The ratchet teeth inside the buckle are designed to firmly grip the strap and may be sharp. Use caution when inserting or removing the belt.
To adjust or loosen the belt while wearing it, press the release lever on the bottom of the buckle and slide the strap to your desired fit.
To completely remove the buckle from the belt, flip the buckle over and lift up on the locking lever located on the back of the buckle. While holding the lever open, slide the strap out of the buckle.
⚠️ Please note: The locking teeth inside the buckle are designed to firmly grip the strap and may be sharp. Use caution when lifting the locking lever and removing the strap.
Yes. The buckle slides off and on, so you can pair it with any Dartee strap in your rotation. Build a bundle and swap a single buckle across colorways if you like.
They’re detachable and secure directly onto the leather strap, slide them anywhere along the belt that feels right, and reposition any time. Leave them off for a clean look off the course.
Absolutely. The marker sits magnetically in the buckle face, so you can switch to your home club’s, a tour favorite, or another Dartee marker whenever you want.
Wipe it down with a dry or slightly damp cloth and let it air dry, keep it out of standing water. A little leather conditioner a few times a season keeps full-grain styles looking sharp for years.
